Bolid S2000-2 User Manual download pdf (Page 43)

S2000-К Maintenance

41 www.bolid.com

INSPECTION

Once per a year personnel of the Service Company shall perform a scheduled inspection of the

S2000-K in order to check its operation condition and find out potential defects. If during the warranty

period the keypad does not meet any requirements set forth in this section, this will be the grounds to

raise a climb to the manufacturer.

An inspection shall be carried out under the normal ambient conditions, namely:

- The temperature of 25 °С

- The relative humidity of 45 % to 80 %

- The atmospheric pressure of 630 to 800 mm

To inspect the S2000-K keypad, do the following:

Ø Examine the keypad for fouling or mechanical damage, than

Ø Examine the keypad terminal blocks and tighten loosen screws if necessary, and

Ø Test S2000-К operability having wired the keypad as shown in Figure 14. The testing procedure

has been described below in this Section.

WARNING!

While inspecting the keypad, disconnect the S2000-K power supply before connecting

and disconnecting wires

Figure 14. Wiring the S2000-K While Testing the Keypad Operability

2000

Power Supply

10-30V, 200мА

XT1.1

XT1.2

2000

(

)

XT1.1

XT1.2

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49 50

No comments

Bolid S2000-2 User Manual Page 43